Macramé Wall Hanging: Beginner Tutorial & Materials
There’s a particular sound a cotton cord makes when you pull a half-hitch tight — a soft, satisfying thwack against the dowel. That’s the sound of a macramé wall hanging coming together. I’ve taught this exact project to hundreds of absolute beginners in village halls and on wobbly Zoom calls, and the same thing happens every time: about twenty minutes in, someone looks up and says, “Wait, that’s it?” Yes, that’s it. A wall hanging is really just three or four knots repeated with patience. The whole thing comes together in an afternoon. You don’t need a studio, a loom, or any prior experience. You need some cord, a stick, and the willingness to undo your first few knots.
Why make one? Because a handmade wall hanging is the rare project that looks expensive and costs almost nothing. It fills that awkward blank wall above the sofa, makes a brilliant housewarming gift, and teaches you a skill you’ll reuse on plant hangers, keychains, and shelf edging. Knotting is genuinely calming, too — it’s the closest thing to meditation that also produces decor.
Materials List
- 4mm cotton macramé cord — about 30 metres for a hanging roughly 40cm wide by 70cm long. 3mm works too and gives a finer, more delicate look, but beginners find 4mm kinder on the fingers. Avoid slick polyester cord for your first go; it slips and the knots won’t hold their shape as forgivingly.
- A dowel or driftwood branch — around 45–50cm long, roughly 1.5–2cm thick. A clean wooden dowel from a hardware shop is perfect. If you collect driftwood, sand any rough patches so the cord doesn’t fray.
- Sharp scissors — craft scissors or fabric shears. Blunt scissors crush the cord ends and make them fluffy.
- A tape measure or ruler — you’ll measure cord lengths more than once.
- Masking tape — to secure the dowel to your work surface while you knot.
- A small comb — for brushing out the fringe at the end. A pet grooming comb works beautifully.
- Optional: a crochet hook — handy for poking small cord ends through tight spaces.
No cord? Thick cotton string, jute twine (rougher on the hands but lovely and rustic), or even old cotton bedsheets cut into strips all work. Just keep your cord thickness consistent throughout, or your knots will look uneven.

Step-by-Step
- Cut your cords. Cut 12 lengths of 4mm cord, each about 2.4 metres long. Yes, that’s a lot of cutting, and yes, the lengths feel absurdly long — but cords shrink dramatically as you knot. Cut one extra length at 2.4 metres in case of mistakes. Lay them flat and smooth so they don’t tangle.
- Mount the dowel. Tape your dowel horizontally to a table or against a wall at roughly eye level, so the ends stick out past your tape. Working upright keeps the cords hanging straight and stops the piece from curling.
- Attach the cords with lark’s head knots. Fold each cord in half to find the middle. Place the loop over the dowel from front to back, pull the two ends through the loop, and tighten gently. Space them evenly across the dowel — roughly 2–3cm apart. Push them close together if you want a denser hanging. You’ll end up with 24 hanging cord ends.
- Divide into working sections. Count your cords from left to right. Work with four cords at a time: the two outer cords are your “working” cords and the two inner ones are “filler” cords. This four-cord group is the building block for everything that follows.
- Knot the first row of square knots. Take the left working cord, cross it over the two filler cords and under the right working cord. Then take the right working cord, pass it under the fillers and up through the loop on the left. Pull both working cords tight. That’s a half square knot. Repeat the mirror image — right cord over, left cord under — to complete a full square knot. Work one square knot in every four-cord group across the row.
- Build the second row with an offset. Skip the first two cords on the left. Starting from the third cord, make square knots across the row again. This staggers the knots and creates that classic diamond lattice pattern. Repeat alternating rows until your hanging is the length you want — usually 8 to 12 rows for a medium wall hanging.
- Finish the bottom edge. Leave the final row of cords loose, or add a row of half-hitches along the bottom for a tidy border. To make a half-hitch, take the far-left cord, loop it around the next cord, and pull through; repeat across.
- Trim the fringe. Decide on your fringe length — 20cm is a good starting point. Gather all the loose ends, hold them flat, and cut straight across with sharp scissors. Cut slowly and check the line as you go; you can always trim more, but you can’t add length back.
- Brush out the ends (optional). Comb the bottom 5cm of each cord to unravel it into soft tassels. This gives a lovely boho finish. Trim the brushed ends to an even line.
- Hang it. Tie a length of cord to each end of the dowel to make a hanging loop, then find your wall. Step back. Admire.

Beginner Tips
The mistake almost everyone makes first: cutting cords too short. Cord length should be roughly four to five times your finished hanging length, and people consistently underestimate this. If in doubt, cut longer — you can trim excess, but you can’t splice on more cord invisibly.
Second, resist the urge to pull every knot drum-tight. Over-tightened knots make the whole piece stiff and warped, and they’re miserable to undo. Aim for firm and even, not clenched. Your tension will naturally even out after the first two rows; the top row always looks a bit wonky, and that’s fine — it becomes the least-noticed part once everything hangs.
Third, count your cords constantly. It’s astonishingly easy to drift by one cord and end up with a lopsided pattern three rows later. Count out loud if it helps. Keep your working cords untangled as you go, too — a tangle discovered ten rows in is a genuine headache. Here’s a counter-intuitive one: don’t practise your knots on scrap cord first. Practising on the real thing, where the stakes are low and the cord behaves as it will in the finished piece, teaches you faster than any rehearsal.
Creative Variation
Once you’ve made one, try a two-tone hanging: use natural cotton for the top half and dip-dye the bottom fringe in indigo or rust. Dye just the last 15cm of the cords before you brush them out, and the colour bleeds upward in a soft gradient that looks far more complicated than it is. You could also add a row of wooden beads threaded onto the filler cords between knot rows — pick beads with holes wide enough for doubled 4mm cord. Beads are the fastest way to make a simple hanging look bespoke, and they hide any slightly uneven knots in that row.
Troubleshooting
Your hanging curls at the edges. This usually means your knots are too tight or your cord count is uneven. Try blocking it: dampen the piece lightly with a spray bottle, lay it flat under a towel with a few books on top, and leave it overnight.
A knot went wrong halfway down. Don’t panic and don’t cut. Loosen the knot by pushing the cords back through the way they came, working gently with a crochet hook if needed. Macramé is one of the few crafts where mistakes are truly reversible — that’s part of its charm.
Your fringe is uneven after brushing. Comb it out fully first, then trim in small snips, checking against a ruler. Brushed cord always looks longer than unbrushed, so trim after combing, never before.
The whole thing feels floppy and shapeless. That’s usually cord that’s too thin for the pattern, or too few cords on the dowel. Next time, pack the cords closer together or size up to 5mm cord for a chunkier, more structured result.
You’ve made something with your hands that didn’t exist this morning. That’s not a small thing. Hang it where you’ll see it every day — above your desk, by the door, wherever your eye lands first with a coffee in hand. Then send me a photo, because I genuinely love seeing what people make from the same few knots. And when someone asks where you bought it, tell them the truth: you made it, in an afternoon, with a stick and some string. Then offer to teach them. That’s how this craft keeps going.